Eastman 35312 Cordiera a ramo flangiato con connessione a giunto scorrevole, 1-1/2 pollici x 8 pollici, bianco

Brand:Eastman

3.3/5

24.06

Presenta una connessione a giunto scorrevole per un'installazione rapida e semplice. Dotato di una presa di innesto OD da 7/8 di pollice per l'installazione in lavastoviglie. Progettato per collegare lo scarico di un apparecchio a una trappola in applicazioni idrauliche tubolari. Costruito in polipropilene resistente per fornire resistenza contro i prodotti chimici domestici. La cordiera del ramo flangiato misura 1-1/2 pollici x 8 pollici.

Presenta una connessione a giunto scorrevole per un'installazione rapida e semplice. Dotato di una presa di innesto OD da 7/8 di pollice per l'installazione in lavastoviglie. Progettato per collegare lo scarico di un apparecchio a una trappola in applicazioni idrauliche tubolari. Costruito in polipropilene resistente per fornire resistenza contro i prodotti chimici domestici. La cordiera del ramo flangiato misura 1-1/2 pollici x 8 pollici.
Brand Eastman
Color White
Connector Type Flange, Trap
Exterior Finish White
Item Dimensions LxWxH 8.4 x 3.3 x 1 inches
Material Polypropylene
Number Of Pieces 1
Size 1-1/2 inch x 8 inch

3.3

3 Review
5 Star
64
4 Star
21
3 Star
0
2 Star
5
1 Star
10

Scrivi la tua recensione

La tua mail non sarà pubblicata. Tutti i campi obbligatori sono segnati con*

Scritto da: sam
Works
The dishwasher port is a tad small but it worked
Scritto da: Lakeviews
Slip joint portion of this product it too shallow (short).
The slip joint ("S/J") section of the tailpiece is too short to provide adequate stability. This product is advertised as working as a direct connect, it can butt up against the sink drain, or as a slip joint, allowing it to partially slip over another section of drain pipe. In my case I only had enough clearances under the sink to mount this item horizontally between the P trap and the stub out from the wall. Mounting it horizontally introduces a bit of torque on the joint where this product slides over the P trap's exit pipe. The slip joint portion of this product is only about 3/4" deep (2mm). To provide sufficient stability it should really be at least an inch deep (allowing the other pipe to slide into it at least an inch. I thoroughly looked at it and the alternatives carried by Amazon and decided to go with this product, even though I suspected the shallowness of the slip joint might be a problem. It is in place and doesn't leak yet, but it's not been subjected to many dishwasher runs. The pulsing of jets of water from the dishwasher during the drain cycle may cause it to fail and start to leak.
Scritto da: C. LuzHoxsie
2nd best option if a garbage disposal is not available.
I had a temporary sink while my counters were getting fabricated and this worked well since I did not have a garbage disposal to hook my dishwasher too.

Prodotti correlati

Scopri il nostro network internazionale

Spediamo in 28 paesi, oltre 200.000 prodotti. Resta aggiornato, iscriviti alla newsletter.

Shopping Cart