Hunter Fan Company 50472 Stockbridge Ventilatore da soffitto per interni con luce a LED e comando a catena, 70, nuova finitura bronzo

Brand:Hunter Fan Company

3.3/5

680.89

Il ventilatore da soffitto Stockbridge dall'appeal di massa si adatterà perfettamente al design moderno degli interni della tua casa. Le belle e pulite opzioni di finitura lavorano insieme all'elevato contrasto degli angoli in tutto il design per creare un look che manterrà il tuo spazio attuale e ispirato. Il ventilatore da soffitto a LED è dotato di lampadine a LED ad alta efficienza completamente regolabili che ti danno il controllo totale sulla tua illuminazione. Questa ventola a montaggio regolabile è dotata di un sistema di montaggio a tre posizioni che consente il montaggio standard, basso o angolato. Passo delle pale di 13 gradi ottimizzato per garantire un movimento dell'aria ideale e prestazioni ottimali. Il downrod da 2 pollici garantisce una distanza adeguata dal soffitto e ottimizza il movimento dell'aria all'altezza della lama preferita. Questo ventilatore reversibile è dotato di pale del ventilatore a rotazione inversa che mantengono le stanze della casa fresche durante l'estate e calde durante gli inverni.

POSIZIONAMENTO DELLA CAMERA: Il ventilatore interno è regolabile in altezza, tramite i 2 downrod inclusi, per garantire una corretta distanza dal soffitto e ottimizzare il movimento dell'aria; Ventilatore ideale per soggiorno, salotto, camera da letto, cameretta dei bambini e asilo nido. CONTROLLO DELLA CATENA DI TRAZIONE: accendi e spegni il nuovo ventilatore da soffitto in bronzo e regola la velocità in modo rapido e semplice con le catene di trazione. LED BOWL LIGHT KIT: le lampadine a LED dimmerabili a risparmio energetico consentono di controllare l'illuminazione e l'atmosfera dello spazio abitativo; Le lampadine a lunga durata hanno una durata maggiore rispetto alle lampadine tradizionali. MOTORE DELLA VENTOLA REVERSIBILE A PIÙ VELOCITÀ: il motore Whisper Wind offre un flusso d'aria ultra potente con prestazioni silenziose; Modificare la direzione dalla modalità downdraft durante l'estate alla modalità updraft durante l'inverno. VENTILATORE DA SOFFITTO CLASSICO: Il tradizionale ventilatore Stockbridge è dotato di luci a LED coperte da un vetro scavo a fiocco di neve che manterrà l'ispirazione per gli interni di casa; Misura 70 x 70 x 17,53 pollici.
Air Flow Capacity ‎4435 Cubic Feet Per Minute
Assembled Diameter ‎70 Inches
Batteries Included? ‎No
Batteries Required? ‎No
Brand Hunter Fan Company
Brand ‎Hunter Fan Company
Collection Name ‎Stockbridge
Color New Bronze finish
Color ‎New Bronze finish
Controller Type ‎Pull Chain Control
Customer Reviews 4.3 4.3 out of 5 stars 97 ratings 4.3 out of 5 stars
Cutting Diameter ‎70 Inches
Electric fan design Ceiling Fan
Electric fan design ‎Ceiling Fan
Finish ‎Painted Cased White
Finish Type ‎Painted Cased White
Included Components ‎Motor, Blades, Light Kit, Light Bulb
Indoor/Outdoor Usage ‎Indoor
Is Discontinued By Manufacturer ‎No
Item model number ‎50472
Item Package Quantity ‎1
Item Weight ‎26.8 pounds
Item Weight ‎26.84 Pounds
Luminous Flux ‎1800 Lumen
Manufacturer ‎Hunter Fan
Material ‎Engineered Wood, Alloy Steel, Glass
Model Name ‎Stockbridge
Mounting Type Downrod
Mounting Type ‎Downrod
Number of Blades ‎5
Number of Speeds ‎3
Part Number ‎50472
Power Source AC
Power Source ‎AC
Product Dimensions 70"D x 70"W x 17.53"H
Product Dimensions ‎70 x 70 x 17.53 inches
Product Dimensions ‎70"D x 70"W x 17.53"H
Recommended Uses For Product Lighting, Indoor, Home
Recommended Uses For Product ‎Lighting, Indoor, Home
Room Type Living Room, Bedroom
Room Type ‎Living Room, Bedroom
Shape ‎Circular
Size ‎70
Special Feature Corded
Special Feature ‎Corded
Special Features ‎Corded
Style Traditional
Style ‎Traditional
Switch Style ‎Pull Chain
Type of Bulb ‎LED
Usage ‎Commercial, Personal, Residential, Business
Voltage ‎120 Volts
Warranty Description ‎Limited Lifetime Motor Warranty is backed by the only company with over 130 years in the fan business
Wattage ‎6.5 watts

3.3

8 Review
5 Star
70
4 Star
8
3 Star
11
2 Star
3
1 Star
9

Scrivi la tua recensione

La tua mail non sarà pubblicata. Tutti i campi obbligatori sono segnati con*

Scritto da: Sean
Super quiet
I got this as a "Used - good" Amazon listing for less than $100 and I'm guessing it was a warehouse deal because the box came in chewed up and the fan was sparkling new in the plastic and undamaged, certainly never installed. It's a monster, so be prepared. The room we placed it in is 18'x20' and it fits the space well, but I wouldn't put it in a room any smaller. Install was straightforward; the ceiling bracket and the fan blades mount via rubber coupler to avoid metal to metal contact and it makes the fan unbelievably quiet. I'll be buying Hunter fans from now on.
Scritto da: John M. Pekarik
Basic fan, about what I expected, plan 2 hours to install
I purchased this fan for our master bedroom, which has about a 12 foot ceiling. I wanted something without a remote control because I have multiple wall switches and prefer to control the light and fan that way. The unit weighs about as much as I expected, though unlike most other ceiling fans I've purchased over the years, this fan comes with one-sided blades. The blades are also thicker than the other fans I have, though they're sturdy - I accidentally dropped one from 12' off the ground onto a hardwood floor, and there were no cracks or damage. It came with an installation bracket, as expected, but the ground wire attached to it is too short. I would recommend replacing it with a longer ground wire before installing the unit. The canopy cover is on the deeper side which means the fitting isn't as tight, but on the down side it makes wiring harder because it obstructs your view. (I was working mostly overhead due to the height of the ceiling.) Speaking of wiring, the instructions tell you to leave 8" of wiring after you trim it to size, but I would recommend 10" instead. The extra length was helpful to have when doing the wiring. The canopy cover has two small screws to keep it in place. These screws are tiny and are difficult to manipulate, and as I discovered the hard way, if you drop one while trying to get it screwed in, it will fall into the fan assembly. Installing the fan blades was a colossal pain because they are heavier than usual and will cause the fan assembly to tilt significantly when the weight is out of balance (i.e. you only have one blade installed). The design of the attachment also forces you to point the blade away from you when installing, because the lip of the blade arm is designed in such a way that you can't see what you're doing if you try to install it while it's facing you. This makes it harder to manage the fan blade and the screws. The final blade is very difficult to install because the fit between the other blades is very precise, and it's hard to get it seated correctly. Having a second person to help during this stage will make a big difference. The fan comes with three LED bulbs, standard shape, but they're only seven watts and are about 50% the size of a regular bulb. They cast an OK amount of light but a larger bulb would be better. I think there is enough room in the globe to fit three standard size bulbs but I haven't tried it yet. The globe is frosted glass...I'm not a huge fan of the pattern but it's OK. The light kit was really easy to attach. The fan is designed in a way that you thread both pull chains down through the bottom of the glass globe. That design is OK, but there is a clip that screws on below the globe, before the cap, and the pull chain tends to get caught and tangled in that clip as you're screwing it in. I got around that for the most part by holding the pull chain against the globe with my thumb while I was screwing the clip on. Putting the globe on was a big enough pain that I don't want to have to take it off again, but I think I can reach over it to get to the bulbs and remove/replace them later on without having to take the globe off. The fan itself is relatively quiet, though it wobbles at high speed. I need to see whether I just need to reorient the fan a bit in its mounting or whether it's a larger balance issue. It took me about two hours to install, in total.
Scritto da: Richard Altavista
Looks great
Its a hunter fan will all the quality and engineering you can expect, very happy with this item.
Scritto da: Imroxy84
Wrong blade color
The fan blades are completely different color than advertised and they are not reversible the other side is painted a grayish brown. There was no remote control. The glass has a paint splatter look not marbled like I thought. The fan does work great and it is quiet just wish the blades were darker wish I read the reviews before purchasing my old fan sounded like fireworks and started raining down fire so I had to find a replacement quickly.
Scritto da: Harry Balls
really good fan for the price
took about an hour to install. could have been faster but I like to take my time with electrical projects
Scritto da: Michelle
Picture item is not what was delivered.
Works great but blade color is medium oak unlike the picture in the description. The blades are also only one sided so there is no flipping them over to another color. The pictured item is a discontinued version of the current fan. I had to call Hunter Fan directly to figure our what is going on with this.
Scritto da: Jo
Easy to install, works great, looks amazing.
Took the old one down and installed this one in about 30 mins. It looks great in our room and puts out better air flow on medium speed than or old one on high. Comes with 3 LED bulbs, but we used our own LED bulbs and it throws out a lot of light.
Scritto da: andrew fitzpatrick
So out of balance.....
Had to buy a balanced kit...

Prodotti correlati

Scopri il nostro network internazionale

Spediamo in 28 paesi, oltre 200.000 prodotti. Resta aggiornato, iscriviti alla newsletter.

Shopping Cart