Graduated Bulge Towers are training tools, progressively dilating of the sphincter, with gaps between the bulges offering a relief of sorts. They can be sat upon, or supported in place with a hand after insertion. Some rarer variants have a long stem which allows the toy to be used also as a plug. Most towers don't. Titanmen Master #4 is a tower that enables the user to get very close to the realm of large anal toys. Gently progressing to the third bulge at 66 mm, the Master would be much easier to capture had it been a little shorter. There is a lot of girth to take over 150 mm of insertable length. I believe it's the most difficult tool of all from the Titanmen trainer/master series. However, the time spent on training will pay off in the future, since toys past 70 mm are obviously girthier, but at the same time tend to be longer, as well, as all that girth has to be distributed somewhere. Build: ------------------ Master #4 features three bulges with two shallow gaps inbetween. The first bulge is a sizeable 47 mm in diameter, with a barely distinguishable tip at the top, which is supposed to help guide the toy in. The bulge is otherwise round, and beginners could consider it a tiny version of a ball plug, such asRound Small . The first gap is reached at 42 mm, and thus does not offer much of a 'relief'. Still, at that girth, it doesn't matter. The second bulge expands to 54 nearly mm, or nearly the maximum diameter of its sister tool, theTrainer #4 , easing down to a 49 mm gap afterwards. At this point, 75 mm of length has been inserted. Halfway there, in other words. The second gap is noticeable, and over the course of many training sessions, it is easy to make friends with. The last and widest bulge clocks in at 66 mm, in the upper medium range for anal toys. The neck which follows the last bulge is 41 mm in diameter, where the sphincter can rest safely. The neck is not all that long, but comfortable enough for the tool to be used as a temporary plug. However, moving about may be difficult, and therefore Master #4 will need some support after the neck is reached, at 150 mm of insertable length. In order to provide some perspective, I'll note that the third bulge offers dilation exactly that of a standard 330 ml can of soda. It's nice to know, once done. Entry: ------------------ This being an upper-medium sized toy, the entry is best attempted in stages, and the build of the Master assists in reaching that goal. The first two bulges can go in without little negotiation, if the insertor has already captured the matching Trainer. A slow push and then a rest at the second gap allows the sphincter to adjust to what lies ahead. All this can be done standing up. It is a good idea to take the tower out and relubricate, paying attention to the third bulge. I have found that sitting didn't get me where I wanted to go. Too much strain. I'm quite used to toys of that girth, and have reached the final rim of Master #4 many times. Never had the cojones to make that final push, because at 150 mm of insertable length, this tower presses at the far back end of the rectum. Since I'm wussy about backdoor pain, I always backed off. The diameter wasn't an issue then. I had to relax and dilate the upper rectum before I could take the Master in safely. To that end, over the course of two days, I used an inflatable plug, pumping it up to nearly 90 mm diameter. Inflatable plugs do not dilate the sphincter, but they do dilate the upper rectum quite well. The next step was relaxing the entry to the sigmoid colon, as the tip of the Master would poke there with its wide top bulb after insertion. For that, I used the soft and very comfortable chain of spades from Master Series, calledAnal Link Large . There are five conjoint spades, the first being the largest at 53 mm. In they all went, and thus I got used to deep penetration that would be my lot after the Master was fully inserted. Capture: ------------------ Once ready, I inserted the first two bulges, set the base at the rim of the sink box, and holding it steady with my hand, I started relaxing my body onto the tower, rather than pushing it in. It is important to keep the sphincter relaxed when this is going on. Any contraction, and failure is imminent. I was ready though, I was dilated in and out, and the Master went in. Although there is a neck and a sturdy, somewhat flared base, this toy is not designed to function as a plug. It will not stay in without support. The base thankfully does not bend, nor does it fold upon itself, and therefore there is no fear that the tower will disappear inside the rectum. These things matter. I keep it in place with the palm of my hand. After I had inserted the tower completely, I try to keep it in as long as I can, which usually means no more than a few minutes. Exit: ------------------ There is nothing easier than letting go of a graduated tower. There is no need to pull -- simply pushing the toy from within by means of sheer muscle power will quickly eject the last bulge, at which point the remainder of the toy can be trivially pulled out, or even pushed out with said muscles, like a bullet. The Master is quite heavy, so I have to be careful not to make a dent in the bathroom furniture, once it's ejected, just like with theTriple Ripple .
